Commissioning
Assembly instructions
DE
EPS Handling systems
Date 08.09.2021
Version 2.0
97–112
6.4.3 Adjusting damping and speeds on pneumatic modules
Setting the speeds on the pneumatic modules
Notes on the setting:
1. The speeds are usually set by the factory to the required cycle time.
2. The set speed can be changed via throttles at the exhaust air outlets on the
control block.
3. If your handling system does not have a control block, the speed can also
be regulated by exhaust air throttles.
6.4.4 External position measuring system
A) Adjust the distance from the sensor to the belt
Notes on the setting:
1. Mount the sensor parallel to the belt using a feeler gauge.
- Value for the distance between sensor and belt (see table).
Sensor type
Distance min.
Distance max.
Recommend
MSK1000
0.1mm
0.2mm
0.1mm
MSA501
0.1mm
1.5mm
0.5mm
2. Adjust the distance between the sensor and the belt.
The desired distance is set.
NOTICE
Risk of damage to property!
Incorrectly set end-position damping can cause damage to the device or the
periphery.
Observe the notes and permissible values.
NOTICE
Danger of material damage in case of incorrect valve actuation!
5/3 directional control valves must not be controlled as impulse valves, as the
modules start up against an empty volume in case of low leakage. The
module is damaged by the high speed and poor damping.
Do not control the valves as impulse valves!