MIRAGE MK III - Broadcast Audio Processor
AEV Broadcast Srl via della Tecnica 33, 40050 Argelato Bologna ITALY
www.aev.eu
3
• Abuse or misuse of the equipment is
extremely dangerous
for people, pets and property. The manufacturer
declines all responsibility for damage and injury resulting from
improper use
and
mishandling
.
• Certain basic safety rules must be observed when using electrical equipment, in particular:
- Never touch the equipment with wet and/or damp hands or other parts of the body.
- Keep the equipment away from drops of water or sprinkling systems.
- Never use the equipment near high heat sources or explosive material.
- Do not introduce any extraneous matter into the equipment.
- Do not allow children or untrained people to use the equipment.
• Before cleaning or servicing the equipment outside, disconnect it from the supply and wait at least 2 seconds before
working on it, as recommended by current safety regulations.
• In the event of faults and/or improper operation, turn off the equipment, shut off the electrical power and call your
dealer. covers/guards or circuit boards are to be removed.
• Blown fuses inside the power supply indicate that there may be a fault in the power supply itself. The fuses must be
replaced by qualified and authorised persons. It is advisable to call your nearest dealer.
• Call your dealer for any repairs and be certain original spare parts are used.
Failure to observe this rule may
adversely affect the safety level of your equipment
.
• The equipment is to be connected to the mains supply and provided with adequate and efficient earth conductors.
• The electrical wiring must be done in compliance with current electrical codes CEI 64-8 “Electrical specification for
domestic buildings”.
• When installing, leave a clearance of at least 1 cm around the equipment to allow air to pass freely.
NOTE. This piece of equipment has been manufactured to the highest standards of workmanship. It must
be used properly and serviced as recommended to ensure long-term dependable operation.
The installation must be done in order to be able to guarantee an easy access to the cable of feeding.
The device of dissection of the equipment is the cable of feeding, so it must be unconnected from the equipment every
time it is ecessary to do any type of maintenance.
Contents
Guarantee ....................................................... 2
Technical Support ................................................2
Factory Service and Repairs ..................................... 2
Shipping Instruction .............................................2
Safety precautions........... ................................... 2
Contents .........................................................3
Introduction - General Description .............................. 5
Total control of peak modulation ................................ 5
Concepts of audio processing .................................... 5
Initial power-up ................................................ 5
Command description ............................................. 6
Front Panel ..................................................... 6
