AEV Matrix 212 MPX
AEV Broadcast Srl
via della Tecnica 33, 40050 Argelato Bologna ITALY
www.aev.eu
mail: [email protected]
3
• Certain basic safety rules must be observed when using electrical equipment, in particular:
- Never touch the equipment with wet and/or damp hands or other parts of the body.
- Keep the equipment away from drops of water or sprinkling systems.
- Never use the equipment near high heat sources or explosive material.
- Do not introduce any extraneous matter into the equipment.
- Do not allow children or untrained people to use the equipment.
• Before cleaning or servicing the equipment outside, disconnect it from the supply and wait at least 2
seconds before working on it, as recommended by current safety regulations.
• In the event of faults and/or improper operation, turn off the equipment, shut off the electrical
power and call your dealer.
• Do not attempt to make repairs and/or adjustments when covers/guards or circuit boards are to be
removed.
• Blown fuses inside the power supply indicate that there may be a fault in the power supply itself.
The fuses must be replaced by qualified and authorised persons. It is advisable to call your nearest
dealer.
• Call your dealer for any repairs and be certain original spare parts are used.
Failure to observe this rule may adversely affect the safety level of your equipment
.
• The equipment is to be connected to the mains supply and provided with adequate and efficient
earth conductors.
• The electrical wiring must be done in compliance with current electrical codes CEI 64-8 “Electrical
specification for domestic buildings”.
• When installing, leave a clearance of at least 1 cm around the equipment to allow air to pass freely.
NOTE. This piece of equipment has been manufactured to the highest standards of
workmanship. It must be used properly and serviced as recommended to ensure long-term
dependable operation.
The installation must be done in order to be able to guarantee an easy access to the cable of feeding.
The device of dissection of the equipment is the cable of feeding, so it must be unconnected from the
equipment every time it is necessary to do any type of maintenance.
