Calibration Procedures:
1. Use the tester black clamp to clip to its red test probe tip as shown above.
2. Switch ON the tester by pressing button. When the display show
immediately press and hold button. [Note: Do not let go until the whole
calibration process has completed.]
2. Moments later the tester will then display with numbers countdown
from 5 to 0.
3. Then it switches to saving mode and seconds later to
and completes the whole calibration.
4.
Release the button, the display will go to and the alarm will
beep continuously. The reading should be 0.00 as shown if not repeat the
calibration procedures again.
5.0 OPERATION:
1. Disconnect the positive power supply to the glow plug terminal.
2. Attach the tester black clip to the vehicle chassis ground (Note: Ensure it is a good
ground contact).
3. Power up the tester by pressing the button once.
4. Its screen will light up and display as follows:
