Installation and user manual for 601V & 601VK intercom systems
1.
Install the batteries in the internal handset. You may need to charge them for a few hours before
testing. It is recommended that in order to achieve maximum battery life, that the batteries get a full
8-12 hour charge at the beginning. Batteries can last several hours between charging.
2.
Once the system is fully wired up, test the working range before mounting hardware. Press the call
button on the out door station. The out door station will chime and the indoor handset should ring
(ensure antenna is extended for best results).
3.
You can answer the call by pressing the answer button as shown.
4.
Test the gate release function, by pressing and holding the open button for 3 seconds.
Please note: Your handset and transmitter have been calibrated to communicate with each other. In the
event that they do not communicate properly even at close range, you may need to re-register the
units together. This will also need done if you are replacing a handset, or adding a second handset to
the system.
Handset coding…
1)
Press and hold the transfer button on a handset. After 3 seconds, one of the 4 lights on the handset
will remain permanently lit. This indicates that the handset has entered into coding mode.
2)
Release the transfer button, and press it again to cycle through the channels. Each LED will light up in
2)
Release the transfer button, and press it again to cycle through the channels. Each LED will light up in
turn indicating channels 1 through to 4.
3)
Repeat this for any other handsets, ensuring that all handsets are set to different codes.
4)
When all handsets have been set into coding mode, press and hold the coding button on the out door
transmitter, until an alert tone is heard.
5)
When the alert tone stops, and the handsets LEDs begin to flash again, this indicates successful coding
completed.
Trouble shooting
Noise or reception problems – Ensure that the base station is not installed near metal objects or reinforced walls. Ensure that the handset
antenna is fully extended, and that the battery is fully charged.
Unit will not work – Check the out door station power LED is on. Check the handset battery is flashing. Double check all wiring. Test the
system at close range. Try re-registering the units as per procedure above.