7351 OPERATING INSTRUCTIONS
CHARGING
Note: Before charging, turn flashlight off.
Dy
namo charging by hand crank
1. Open DYNAMO HAND CRANK and rotate clockwise at approximately 120 cycles/minute
for a minimum of 1 minute. Winding for longer periods of time will yield longer power
durations.
2. Close DYNAMO HAND CRANK and unit is now ready for use.
3. If desired to verify that charging is taking place, remove the DC IN/OUT PORT cap
to exposes the small green LED charge indicator light. Caution: Close cap and
seal completely to assure waterproof integrity after charging and before use. Do not
open cap under water.
4. Unit may also be charged under water.
AC/DC Adapter charging (adapter not included)
1. Charge the internal battery of the flashlight for increased standby power by using an
auxillary AC/DC ADAPTER (part #7990, sold separately; refer to last page for
specifications).
2. Remove the DC IN/OUT PORT cap to expose the DC IN/OUT PORT.
Carefully plug the small male connector of the AC/DC ADAPTER into the DC IN/OUT
PORT. Plug the adapter into an approved 120V AC power outlet. Verify that the charge
is taking place by assuring the small LED indicator light is illuminated. Close cap and seal
completely to assure waterproof integrity after charging and before use.
3. Full charge times are indicated in the specifications on the back page.
Charging a cell phone
1. Unit charges cell phones by using the DYNAMO HAND CRANK.
2. Flashlight includes a Nokia cell phone adapter tip to match most common Nokia
phones. Additional cell phone adapter tips for other common phones are available (part
#7995, sold separately).
3. To charge your phone, connect the Universal DC cable into the DC IN/OUT PORT
of the flashlight. Plug the other end of the cable directly into the Nokia phone, or the
appropriate adapter tip for your phone.
4. Wind the flashlight DYNAMO HAND CRANK for a minimum of 1–3 minutes for a
1-5 minute phone call, depending on cell phone model. Longer cranking duration will
increase talk time ability.
FLASHLIGHT OPERATION
Press the ON/OFF BUTTON located on front of flashlight.
• Press once to activate the 2 left and right side LEDs
• Press twice to activate center 1-watt single LED
• Press third time to activate 1-watt single LED with flashers
• Press fourth time to turn flashlight off
1-Watt Waterproof Flashlight
SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS
• Read all instructions before operating
• Do not look directly at the light; may cause inju
ry to your eyes
• Do not use in flammable or explosive environments
• Do not operate at temperatures above 120°F or below 32°F
•
Turn off flashlight before charging
• Do not use alcohol, flammable or other solvents on or near t
his unit-only clean
with warm water and soft cloth
• Protect LED lens from damage and scratching
• Administer close supe
rvision when using around children
• Never use or submerge in water with DC CAP removed
PARTS IDENTIFICATION
ON/OFF BUTTON
DC IN
DC OUT
PORT
CHARGE
INDICATOR
LIGHT
DYNAMO
HAND
CRANK
LED
1-WATT LED
LED
(under cap)
(not visible)
