5
STEP ONE – INSTALL KITCHEN FAUCET ADAPTER
1.
Identify the cold water line in the sink cabinet.
Turn off the cold water supply to the sink.
2.
Turn on the kitchen faucet to release pressure and
allow water to completely drain from the line.
3.
Disconnect the cold water line from the 1/2” threaded
stem on the bottom of the kitchen faucet.
Notice: You may need a plumber to shorten the supply line pipe
using a hacksaw or pipe cutter to accommodate the
Kitchen Faucet Adapter if pipe is rigid.
4.
Holding the (F) Kitchen Faucet Adapter (See Package Contents on page 3)
in an upright position and screw onto the threaded kitchen faucet stem.
(See diagram on page 4)
5.
Screw the cold water supply line to the male threads of the Kitchen
Faucet Adapter using the nut that was previously connecting the cold water
line to the kitchen faucet
.
WARNING
Be sure that all electrical appliances and outlets are turned off at the circuit
breaker before working in the cabinet area.
!
Drain Connector Assembly
Front Plate
STEP TWO – INSTALL RO DRAIN CONNECTOR
1.
Identify drain outlet location.
2.
From back of foam seal, remove protective cover.
Knock center hole out, align holes, and attach
to front plate of drain connector.
3.
Allowing room for drilling, position
the drain connector on sink drain
pipe above drain trap.
4.
Securely tighten nuts and screws.
5.
Using drain connector port as drill guide, drill 7/32”
hole through wall of drain pipe. Be sure not to penetrate
opposite side of pipe, and be careful not to damage side
of drain port fitting.
CAUTION
!
Please wear safety glasses to protect eyes when drilling.
