8001559
INSTRUCTIONS TUBÒ | ROBÒ ITR806 KIT WIRELESS
WITH START/STOP CENTRAL POWER UNITS
WITH TRANSMITTER-RECEIVER AND ADAPTER SUPPLY (SPARE)
EN
INSTALLATION
CONNECTION
SUPPLIED COMPONENTS
T -
wireless transmitter with ROBÒ base
A -
start/stop button
B -
wireless signal LED
C -
battery
D -
transmitter fixing support with screw
2
-If there isn’t a hole for the vacuum detection hose in the body of the vacuum
unit, you will have to drill a 7mm diameter hole
(H
),
and then insert the depression
detection tube
(E)
into the body of the power unit.
3
- Connect two wires of the cable
(F)
to the central vacuum cleaner’s line 12V
(M)
then power the receiver
(R)
using the adapter supplied
(N)
REMARK
If the vacuum system is started from the sockets circuit, it can’t be turned off with
the radio control.
S1
S2
A
B
T
C
V
T
T
R
R
D
1,5 meter
H - HOLE 7 mm.
E
F
M
1
-Position the receiver
(R)
near the central vacuum unit
at a distance of roughly 1.5 meters
Fix the receiver
(R)
to the wall with the screws and dowels
supplied
(V)
N
R
E -
depression detection tube
F -
cable for 12V line activation
R -
appliance
wireless receiver
V -
screws with plugs
N -
12V adapter power supply
R
V
N
E
F
R
OPERATING FREQUENCY
433.92 Mhz
ACTUAL RADIO POWER
0.3mW
TYPE OF MODULATION
amplitude
(ON OFF)
ABSORPTION DURING
TRANSMISSION
10mA
COMPLIANCE WITH DIRECTIVE 99/05/EC
The remote control is compliant with the essential
requirements provided by Directive 99/05/EC.
The following Technical Standards have been applied:
EN 60335-1, EN 301489-3, EN 300220-3
ATTENTION
If a house has several floors,
we recommend installing the
receiver
(R)
on the middle floor.
The Receiver
(R)
cannot be
installed outside the house.
Inside a building, the operating
range between the receiver
(R)
and the transmitter
(T)
is 15m.
and it is capable of intersection
two floors
(S1 - S2)
