Aerotech XC2e, Hardware Manual, Page: 45 / 92

2.3.2. Hall-Effect Inputs
The Hall-effect switch inputs are recommended for AC brushless motor commutation but not absolutely
required. The Hall-effect inputs accept 5 VDC level signals. Hall states (0,0,0) or (1,1,1) are invalid and will
generate a "Hall Fault" axis fault.
Refer to Section 2.2.1.1. for Hall-effect device phasing.
Table 2-16: Hall-Effect Feedback Pins on the Feedback Connector
Pin # Description In/Out/Bi
3
+5V Power
(1)
N/A
5 Hall-Effect Sensor B (brushless motors only) Input
10 Hall-Effect Sensor A (brushless motors only) Input
11 Hall-Effect Sensor C (brushless motors only) Input
16 +5V Power
(1)
N/A
20 Signal Common N/A
21 Signal Common N/A
(1) The maximum combined current output is 500 mA.
Figure 2-18: Hall-Effect Inputs Schematic (Feedback Connector)
www.aerotech.com 45
XC2e Hardware Manual 2.3.2. Hall-Effect Inputs