Aerotech Soloist MP 10, Hardware Manual

Page: 67 / 94

-IO Expansion Board Soloist MP
3.3.2. Differential Analog Input 1 (TB202)
To interface to a single-ended (non-differential) voltage source, connect the signal common of the source to
the negative input and the analog source signal to the positive input. A floating signal source should be
referenced to the analog common as shown in
Figure 3-5 .
Table 3-9: Differential Analog Input 1 Specifications
Specification Value
(AI+) - (AI-)
+10 V to -10 V
(1)
Resolution (bits) 12 bits
Resolution (volts) 4.88 mV
1. Signals outside of this range may damage the input
N O T E : Analog Input 0 is available on J103 (see Section 2.3.7. ).
Table 3-10: Differential Analog Input 1 Pins on the Analog I/O Connector (TB202)
Pin# Description In/Out/Bi
1 Analog Common N/A
2 Non-inverting Analog Input 1 Input
3 Inverting Analog Input 1 Input
Figure 3-5: Analog Input Typical Connection (TB202)
www.aerotech.com Chapter 3 67