Aerotech Soloist CP 10, Hardware Manual

Page: 99 / 112

Accessories Soloist CP
4.2. Handwheel Interface
A handwheel (such as the Aerotech HW-xxx-xx) can be used to manually control axis position. The
handwheel must provide 5V differential quadrature signals to the Soloist CP.
A handwheel can be connected to the Aux I/O as shown in Figure 4-5 or Figure 4-6 .
N O T E : See the Soloist Help file for information on enabling the handwheel.
Figure 4-5: Handwheel Interconnection (to Aux I/O)
Figure 4-6: Handwheel Interconnection (to Aux I/O via a BBA32 Module)
www.aerotech.com Chapter 4 99