Aerotech Ndrive QL Series, Hardware Manual

Page: 20 / 50

Installation and Configuration Ndrive QL Hardware Manual
2.2. Electrical Installation
The Ndrive QL has one AC input power connector. For a complete list of electrical specifications, refer to
Section 1.1. Electrical Specifications .
2.2.1. Power Input (TB101)
AC input power to the QL is applied to the Input Power (TB101) connector.
The connection requires a minimum of 100 VAC input to operate properly. The AC1 and AC2 inputs are
internally fused.
Figure 2-1 shows the required connections to the control power input.
POWER INPUT
AC1
AC2
TB101
100-240V~
50/60Hz
2A MAX
Figure 2-1: Power Input Connections
Table 2-1: Power Supply Wiring (TB101)
Pin Description Recommended Wire Size
AC1 100 - 240 VAC Input Range
1.3 mm
2
(#16 AWG)
AC2 100 - 240 VAC Input Range
1.3 mm
2
(#16 AWG)
Protective Ground (Required for Safety)
1.3 mm
2
(#16 AWG)
Type Aerotech P/N Phoenix P/N
Screw Torque
Value: Nm
Wire Size:
AWG [mm
2
]
3-Pin Terminal Block ECK00213 1754465 0.5 - 0.6 12-30 [3.3 - 0.516]
20 Chapter 2 www.aerotech.com