Aerotech Ndrive HPe 10, Hardware Manual

Page: 109 / 126

Accessories Ndrive HPe 10/20/30
5.2. Handwheel Interface
A handwheel (such as the Aerotech HW-xxx-xx) can be used to manually control axis position. The
handwheel must provide 5V differential quadrature signals to the Ndrive HPe 10/20/30.
A handwheel can be connected to the Aux I/O as shown in Figure 5-5 or Figure 5-6 .
N O T E : See the A3200 Help file for information on enabling the handwheel.
Figure 5-5: Handwheel Interconnection (to Aux I/O)
Figure 5-6: Handwheel Interconnection (to Aux I/O via a BBA32 Module)
www.aerotech.com Chapter 5 109