Aerotech Automation1 iXL2e, Hardware Manual

Page: 42 / 96

2.3.2. Hall-Effect Inputs
The Hall-effect switch inputs are recommended for AC brushless motor commutation but not
absolutely required. The Hall-effect inputs accept 5 VDC level signals. Hall states (0,0,0) or (1,1,1) are
invalid and will generate a "Hall Fault" axis fault.
Refer to
Section 2.2.1.1. for Hall-effect device phasing.
Table 2-17: Hall-Effect Feedback Pins on the Feedback Connector
Pin # Description In/Out/Bi
3
+5V Power (1)
Output
5 Hall-Effect Sensor B (brushless motors only) Input
10 Hall-Effect Sensor A (brushless motors only) Input
11 Hall-Effect Sensor C (brushless motors only) Input
16
+5V Power (1)
Output
20 Signal Common Output
21 Signal Common Output
(1) The maximum combined current output is 500 mA.
Figure 2-19: Hall-Effect Inputs Schematic (Feedback Connector)
iXL2e/XL2e Hardware Manual
42 www.aerotech.com