The Assembly in Individual Steps:
Fix the pressure gauge to the suction line. Ensure that
the pressure gauge can be easily read. Then screw
the valve on to the line below. The nipple must now be
connected to the valve, after that, fit the connection in
to the line:
Both sides of the water trap must now be fitted with a
nipple. After this, fasten each of the compressed air
feed and the valve to a nipple:
Now lay the tank on a scratch-free surface with the
retaining lugs uppermost and screw the pre-
assembled water trap in to the free bore of the
suction line. Then screw the connecting tube to the
side bore of the tank.
Then align the pressure gauge and the suction line:
Now screw the nipple in to the lower tank opening and
after that, the sand regulator. To this, there follows an
additional nipple. Now screw the sand outlet to the
nipple:
Now assemble the blasting grip: Fix the nozzle of
choice in the jaws, screw on a nipple and firmly
connect the hose with the tank and the blasting grip
and secure each with the clamps. Pay special
attention to a tight fit as a pressure of up to 8.5 bar
can arise. Lack of tight fit can lead to serious injuries!
Finally, the handle and the wheel set must be fitted in
accordance with Chapter 1.
Filling with Blasting Media:
Wherever possible, only use blasting media of silicon,
carbide or aluminium oxide. Sand, due to its natural
constituents can lead to blockages. In addition, sands
wear out the machine more and are less effective in
their application.
The blasting media must be completely dry otherwise
this can also lead to blockages.
Before the filling process, disconnect the machine
from the compressed air supply and completely
relieve the pressure. Ensure that the pressure gauge
indicates 0!!
Then remove the tank cover, put the funnel in the
filling aperture and half fill the tank, maximum,
however, to ¾. The higher the humidity in the
atmosphere, the less the tank should be filled!
Close the tank after the filling.
Close the shut-off valve and open the valve after it
has been ensured that the blasting gun is locked at
the nozzle.
Then connect the machine to the compressed air
supply and switch it on.
Always wear protective clothing!
9. Safety Advice for Operators
Only use the equipment after you have carefully read
the operating instructions.
Observe all safety advice given in the operating
instructions.
Behave responsibly towards other people.
