3
AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL
AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL
AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL
in the front edge.
2. Pushing the rear edge until it has “clicked”.
NOTE:
•
Make sure the fuel cell valve is attached
fi rmly, if not, gas leakage may occur and
create hazards to users and bystanders.
E. Installing and removing fuel cell
Caution !
•
Make sure the trigger is not held while
inserting fuel cell.
•
Empty fasteners in the magazine before
installing fuel cell.
•
Do not press on the surface ground while
installing.
Steps:
1. Push up and pull to open the fuel door.
2. Insert the fuel cell, direct the jet nozzle into
the adaptor.
3. Put the can door over the valve and push it
down to latch.
4. For removing fuel cell, reverse the above
steps.
F. Loading the pins
Caution !
•
Make sure the trigger is not held while
loading the pins.
•
Do not press on the surface ground while
loading.
Steps:
1. Pull the follower holder to the bottom of the
magazine, until it locks at the bottom.
2. Load the pins into the slit in the rear of the
magazine until they reach the top of pin stopper.
3. Further pull the follower holder, press the
button on the pin carrier and release it gently.
4. For removing the pins, lock the follower at
the magazine bottom and the pins will slide down.
Further pull the follower for releasing all the pins.
G. Driving the pins
Caution !
•
Please READ and UNDERSTAND the
section “General Safety Instructions” for
personal and working environment safety.
•
If you spot of any abnormality about the tool,
contact nearest
authorized serviceman for
inspection and repairing.
Steps:
1. Press the Nose of the contact arm against
working surface (90° against the surface) fi rmly
until you hear the fan motor is working.
2. Pull the trigger, the pins are driven to the
object.
3. Release the trigger and lift the tool.
H. Cleaning jam
Jamming of pins could be evident if users cannot
drive the fasteners properly, try following steps in
subsequent order.
Caution !
•
Place the tool on flat surface prior to
releasing the magazine, magazine may pop
off suddenly.
•
Read previous sections to fully understand
battery cartridge installation/removal and
unloading fasteners.
Steps:
