10
Aligning Spray
1. Relieve pressure. Set trigger lock
2. Loosen guard Horizontal Vertical retaining nut
3. Align guard horizontally to spray a horizontal pattern.
4. Align guard vertically to spray a vertical pattern.
Spray instruction
CHECK
to ensure that the shipping seal has been removed from under the cap on the hydraulic tank.
Hydraulic tank should be at least 3/4 full of hydraulic fluid.
1. During paint spraying, hold the gun upright to the surface of paint-object and keep a constant spraying distance of 350~400mm.
(Fig.4)
2. Move gun before starting the trigger. Equably move gun when spraying. At last, loosen the trigger and stop moving immediately.
Adjust moving speed according to thickness of paint, spray pressure and the distance of gun to object.
3. In order to get an intact and slick surface, spray from level and vertical respectively. Spraying time will be variable with different
paints. Spray for second time when the first painting is dry.
Begin spraying on well spray stop spraying
(Fig.4)
4.
During your spraying if you need to stop for several minutes, loosen the pressure valve and revolve
prime valve in counter-clockwise, then shut the motor. Put spraying tip into solution in case of paint
block-up in the spraying tip.
Airless Sprayer Cleaning Procedure
When spraying tip is block-up, revolve it 180 degree for several times, then move back in position
of well-spraying.
Fig.5
Step 1: Engage trigger safety lock on gun. Revolve 180 degree
Step 2: Turn off pump and release fluid pressure by turning the pressure relief prime valve located on the engage trigger
safety lock on gun. side of the pump down.
Step 3: Engage trigger safety lock on gun, Revolve 180 degree then open the safety lock.
