5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a reduction in power and efficiency.
6. For better performance, install a quick connector in your tool and quick coupler on the hose if possible.
7. Be sure all connections in air supply system are sealed to prevent air loss.
Loading fastener and operation
WAR N I N G :
Always disconnect the tool from the compressed air before loading. When loading the tool always point
the tool away from yourself and others. Make sure that you are not holding the tool with trigger depressed while loading the
tool.
1. Insert a strip of fasteners into magazine Keeping it point down.
2. Release the latch and pusher, slid the pusher against the nails.
3. Connect the tool to the air supply. Make sure the air pressure is in the correct range denoted in the Technical Data.
4. Then test the driving depth in a sample piece of wood before using. If the fasteners are being driven too far or not far
enough, adjust the regulator to provide less air pressure or more air pressure.
5. Never operate tool unless safety nose is contact with workpiece. Do not operate tool without fasteners or damage to
tool may result.
6. Never fire fasteners into air because fasteners may injury operator or others and damage to tool may result.
※
Maintenance
WAR N I N G :
Disconnect the tool from the air compressor before adjusting, clearing jams, servicing, relocating and
during non operation.
·Regular lubrication, if your tool without using the in-liner automatic oilier, place 2 or 6 drops of pneumatic tool oil into
the air inlet before each work day or after 2 hours of continuous use depending on the characteristic of workpiece or type of
fasteners.
·Check and change all worn or damaged o-rings, seals, etc. Tight all the screws and caps in case
personal injury.
·Inspect trigger and safety mechanism to assure safe system is complete and functional: no loose and missing parts,
no building or sticking parts.
·Keep magazine and nose of tool clean and free of any dirt lint or abrasive particles.
※
Troubleshooting
The following form lists the common operating system with problem and solutions. Please read the form carefully and
follow it.
WAR N I N G :
If any of the following symptoms appears during your operating, stop using the tool immediately, or
serious personal injury could result. Only a qualified persons or an authorized service center can perform repairs or
replacement of tool.
Disconnect tool from air supply before attempting repair or adjustment. When replacing O-rings or Cylinder, lubricate with
air tool oil before assembly.
