10
3. With finger off the trigger, depress the push lever against the workpiece.
THE NAILER MUST NOT OPERATE.
4. Without touching the trigger, depress the push lever against the workpiece. Pull the trigger.
THE NAILER MUST OPERATE.
5. With the nailer off the workpiece, pull the trigger. Depress the push lever against the workpiece.
THE NAILER MUST OPERATE.
6. If no abnormal operation is observed, you may load nails in the nailer. Drive nails into a test piece that is the
same type of material that will be used in the actual application.
THE NAILER MUST OPERATE PROPERLY.
Firing modes
The Air-powered Coiled Siding Nailer has two firing modes: sequential fire for single firing, or bump fire for
repetitive, fast firing of nails. The bump fire trigger kit comes installed on the nailer, and the sequential fire trigger
kit is included as replacement parts. See instructions on how to change from one mode to the other.
METHODS OF OPERATION
This nailer is equipped with a push lever at the nailing point and will not operate unless the push lever is
depressed (pushed upwards). Each mode requires a different method of operation:
1. Sequential fire (single shot)
①
Position the nail outlet on the workpiece with finger off the trigger.
②
Push the nailer down until the push lever is completely depressed.
③
Pull the trigger to drive a nail.
④
Remove finger from the trigger.
⑥
To drive another nail, move the nailer along the workpiece, repeating steps 1 to 4 as required.
