9
COIL ROOFING NAILER CN45RA
Clear A Jammed Nail
To clear a jammed nail
• Disconnect the tool from the air supply line.
• Open the nail guide and insert a rod into the outlet.Tap the rod with a hammer.
• Remove the jammed nail with a slotted screwdrive.
• Cut the deformed collated wire with shipls.Correct the deformation.
• Remove the non-jammed nails that are stored in the tool's magazine.
• Operate the magazine latch and slide the pusher back to open the magazine for checking the jammed nails.
• Use pliers or any appropriate tool to remove the jammed nails.
• Close the magazine cover and slide the pusher to its original position.
• Reload the nails into the tool magazine.
• Reconnect the air supply line to the tool's air inlet.
• Test fire 3 to 5 nails into a piece of scrap wood in order to ensure proper operation.
Maintenance
•
Disconnect the tool from the compressor before adjusting, clearing jams, servicing &maintenance, relocating
and during non operation. Regular lubrication, if your tool without using the in-liner automatic oilier, place 2 or 6
drops of pneumatic tool oil into the air inlet before each work day or after 2 hours of continuous use depending in
the characteristic of workpiece or type of fasteners.
•
Air-operated tools must be inspected periodically, and worn or broken parts must be replaced to keep the tool
operating safely and efficiently. Check and change all worn or damaged O-ring, Seals, etc. Tighten all the screws
and caps to avoid personal injury. This should be done by an expert.
Make regular inspection for free
movement of trigger, Spring and safety mechanism to assure safe system is complete and functional: no loose
and missing parts, no building or stocking parts. Keep magazine and nose of tool clean and free of any dirt lint
or abrasive particles. When temperatures are below freezing, tools should be kept warm by any convenient,
safe method.
