Serial Number: 1203
32
that both flaps are in the same position.
Install cabin ceiling covers, check function of ailerons and flaps, screw-on anchoring
lugs
3) Disassembly
Drain all fuel
Remove ceiling covers
Remove and move strut covers
Perform disassembly in reverse order of assembly. Disassembled wings may only be
placed on soft rests or hanged on stands using their fittings as anchors. Remove elevator
using similar procedure.
5.22 Long-term storage and transport
Before long-term storage
Remove battery and connect to maintenance charger
Drain all fuel from the tanks through drain valves
Apply preservation to the engine following manufacturer’s instructions
Cover glass parts of cabin and/or wings and tail surfaces
Support main landing gear legs using assembly stands or ensure periodic checking of tire
inflation
Put protective covers on propeller blades
Transport
The aircraft may only be transported with wings removed. When transporting over
longer distance or in closed cargo bay of a truck, elevator must be removed. If elevator is
not removed, it must be fitted with red pennants, or accompanying vehicle must be
procured.
During the transport, the fuselage must be connected to truck or trailer by landing gear
legs and possibly also by tail bumper. The wings must be anchored using their central-
section fittings and wing tip nor leading edges may contact the floor nor be leaned on
anything.
Flap controls must be fixed in position – see section Disassembly. If elevator is
transported separately from the fuselage, it must only be fixed using fuselage fittings and
front pins. Entire elevator must be protected by soft cover and attached to the truck or
trailer using wide straps.
