4
AP1130 and AP170 5-GHz Directional Antenna Installation Guide
Connecting the Antenna to the AP
Use the two antenna cables with N-Male to connect the antenna to the AP, as
shown in the illustration at the left (an AP1130 is shown here). The optimum
distance between the devices should be approximately 3’ (1 m). If there is too
much space between the devices, the signal will degrade. It is not necessary to
ground the antenna.
Aligning the Antenna
Two people are required to test the elevation and alignment for maximum signal
strength. While one person takes readings on an RF test meter, the second
person makes adjustments as necessary by loosening the hex nut on the
mounting bracket and tilting or turning the antenna chassis. Use the angle
markings on the bracket as guidelines, as shown in these illustrations below to
help align the antenna horizontally and vertically as needed.
You can use 2.4 GHz antennas in addition to the 5 GHz directional
antenna. Always install a 50-Ohm load terminator on any unused
antenna connector.
0
15
15
Loosen hex nut to
tilt antenna
Mast
Antenna
Bracket
Loosen hex nut to
rotate antenna
Mast
Antenna
Bracket
Loosen hex nut to
rotate antenna
10 20 30 40 50
10 20 30 40 50
10 20 30 40 50
50 40 30 20 10
0
