P/N 330098-01
3
H
IVE
M
ANAGER
A
PPLIANCE
M
EMORY
U
PGRADE
I
NSTRUCTIONS
Figure 3 Install the memory card
9. Replace the device cover and reinsert the six cover screws (three on each side of the device.)
10. Replace the rack mount brackets and re-install the device in a rack.
11. Reconnect device power.
12. To verify that your upgrade was successful, establish a console or SSH connection to the device, enter 2
(Display System Information) > 5 (Display Hardware Information) as shown in this output example:
1) Network Settings and Tools
2) Display System Information
3) Advanced Product Configuration
4) Reboot Appliance
5) Shut down the System
6) Change CLI Shell Password
7) Logout of shell
Please make a choice:
2
1) Display Physical Address Information
2) Display System ID
3) Display Open Ports
4) Display Disk Usage
5) Display Hardware Information
6) Back to Parent Menu
Please make a choice:
5
These are the present cpu frequency, memory and model number informations.
cpu MHz: 3400.537 [2core CPU]
MemTotal:
3107840
kB
Model Number: 1U
Your memory installation is complete. You are ready to proceed with your software upgrade to
HiveManager 6.0r1.
If you have any problems installing the memory card, or if your device does not operate properly after you
have installed the card, contact Aerohive Technical Support.
Rotate the memory
slot tabs outward.
1
Insert memory card
firmly into slot.
2
Rotate the slot tabs inward
to secure memory card.
3