To register, get the latest product documentation, see compliance information,
and download software updates, visit
www.aerohive.com/support.
BR200 Series Router Ports and Connectors
Aerohive BR200 series routers are available in two models: the BR200-WP and the BR200. The following
illustration shows the ports, connectors, and LEDs on the rear panels of these devices.
BR200 Series Status LEDs
BR200 series router Status LEDs cycle through the following states:
•
Dark
: There is no power or the status LED is disabled.
• Steady Amber
: The device has power and is establishing network and CAPWAP connections. If the LED stays
amber and does not change to white after 10 minutes, check the physical connections and see if the router
appears in the Monitor section in HiveManager. If not, use the resources listed below for troubleshooting
assistance.
• Flashing Amber:
The device is performing a firmware update. It is very important not to turn off the device
during this process.
• Steady White
: The device is connected to HiveManager and operating properly.
3
Connect wireless and PoE devices (BR200-WP only) and LAN devices to your router.
P/N 330069-01 Rev. A
Link status
LEDs
Security
connector
USB
port
Reset
button
WAN
port
Power
connector
48V (1.25A)
ETH1/PoE ETH2/PoE ETH3 ETH4 WAN/ETH0
Console
USB Reset
10/100/1000 Base-T
Console
port
48V (1.25A)
ETH1 ETH2 ETH3 ETH4 WAN/ETH0
Console
USB Reset
10/100/1000 Base-T
BR200-WP
BR200
PoE status
LEDs
Link status LEDs
LAN ports
Wireless devices and powered
devices connected to ETH1/PoE and
ETH2/PoE ports (BR200-WP only).
