Aerohive Networks Aerohive APs, Hardware Reference Manual

Page: 63 / 93

Chapter 5 AP110 and AP120 Platforms
62 Aerohive
AP110
AND
AP120 P
RODUCT
O
VERVIEW
The AP110 and AP120 are both multi-channel wireless access points. The AP110 contains a dual-band radio that
can operate at either 2.4 GHz or 5 GHz—but not in both bands simultaneously. The AP120 contains a 2.4 GHz
radio and a 5 GHz radio that can operate concurrently through four internal antennas. The AP100 series
supports a variety of Wi-Fi (wireless fidelity) security protocols, including WPA (Wi-Fi Protected Access) and
WPA2.
You can see the hardware components on the HiveAP in
Figure 1 . Each component is described in Table 1
"AP110 and AP120 component descriptions" .
Figure 1 AP110 and AP120 hardware components
Table 1 AP110 and AP120 component descriptions
Component Description
Status Indicator The status indicator conveys operational states for system power,
firmware updates, Ethernet and wireless interface activity, and major
alarms. For details, see
"Status Indicator" on page 64 .
Device Lock Slot You can physically secure the HiveAP by attaching a Kensington lock
and cable to the device lock slot. For more information, see
"Locking
the AP100 Series Device" on page 66 .
Reset Button The reset button allows you to reboot the device or reset the HiveAP
to its factory default settings. Insert a paper clip, or something similar,
into the Reset pinhole and press the reset button. To reboot the device,
hold the button down between 1 and 5 seconds.
Reset pin Device lock slot ETH0
PoE port
48 VDC
Status indicator