RN200 Mono Software User Manual
12
3.2
Active Test / RF Test
3.2.1
Active/non-signaling RF test with built-in test module
An example of test system setup when using the internal test module is shown in Figure 8.
Figure 8: Active/RF test system diagram (with ODC200)
Cables connection instructions:
1.
Directly connect the RN200 to the control PC via the LAN port with an RJ45 cable or
through a network switch (optional).
2.
Use a USB cable, and connect the device’s USB Type-B port on the interface panel with a
USB port on the control PC.
