RN200 Mono Software User Manual
10
3
System Diagram
3.1
Passive Test
3.1.1
Passive test with built-in test module
An example of test system setup when using the internal test module is shown in Figure 6.
Figure 6: Passive Test System Diagram (with ODC200)
Cables connection instructions:
1.
Direct connection to the RN200 to the control PC via the LAN port with an RJ45 cable or
connect to a network switch (optional) firstly then connect to the control PC indirectly.
2.
Use a USB cable, and connect the device’s USB Type-B port on the interface panel with
the USB port of the control PC.
3.
Connect the DUT to the RF port on the positioner with an RF cable.
3.1.2
Passive test with test instrument
An example of test system setup when using a standard test instrument is shown in Figure
