S1
0
p
lu
s
Assembly
www.aerocompact.com
26
The long ballast tray can be installed in the following positions:
across the front bracket.
underneath the middle bracket, attached to one side.
on the connector bracket.
across the end bracket (last row, mirror of front bracket).
Refer to the Aerotool planning documents for the exact number and location of long ballast trays.
Placing the roof protection pads
Depending on the length of the ballast tray, a different number of protection pads are required per ballast
tray:
Length 1800 mm: 3 roof protection pads per ballast tray
Length 2050 mm: 4 roof protection pads per ballast tray
Length 2300 mm: 5 roof protection pads per ballast tray
When positioning the protection pads, make sure
that the drain holes at the bottom of the ballast
tray are not covered.
Distribute roof protection pads evenly under the
ballast trays.
Install the long ballast tray on the initial bracket or connector bracket.
When several ballast trays are placed side by side:
Lay out ballast trays so that they overlap at the connector brackets or end brackets
.
Attach the ballast tray to the brackets with a washer and ALtracs screw
.
Tighten the screws with 15 Nm or 11 ft lb.
If specified in the planning documents (optional):
Screw the bottom of the ballast trays to the connector brackets or end brackets.
Tighten the screws with 15 Nm or 11 ft lb.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
