ADAPTER MOUNTING for helicopter skids and operation (optional)
1.
Place adapter bars into the open ends of the frame.
2.
Approach helicopter from the front allowing adapter to fit skids as needed
secure the straps.
3.
Secure adapter to gear depending on adapter type and tighten
accordingly.
4.
Tight the straps around skids, firmly.
5.
Lift the front section of helicopter by use of manual hydraulic lifting device.
6.
Start moving the unit at slow speed , slowly increase the speed.
7.
The spring loaded drive on ramp is mounted in the front by two metal
hook adapters, which are bolted on and spring it put in place.
8.
The master battery switch must be off when unit is not in use.
9.
To start operation, select master switch on, then select key on. There is
also an emergency shutoff switch need the handle.
10.The handle has two grips, which are turned clockwise / counter clockwise
to adjust the speed.
Aero-Pac jetmover® Operation :
Check for obstacles during tow operation. Perform aircraft fuel check and oil
check of aircraft before starting tow operations.
Use Chocks: When returning the aircraft to the hangar, use chocks to prevent
hitting the rear of the hangar or other obstructions.
Always check for clearance around the entire aircraft prior to moving the aircraft.
Operating Speed: The electric jetmover is designed to operate at a slow walking
speed for safety .
