Scarlet
Scarlet building instructions
2
Parts List
1) Fuselage, white pigmented
1
GRP, ready made
2) Canopy, black
1
Ready made
3) V-tail and control surfaces
2 (l + r)
Wood construction, ready made
4) Wing centre section with flaps, covered
1
Styrofoam / wood, ready made
5) Outboard wing panels with ailerons, covered
2 (l + r)
Styrofoam / wood, ready made
6) Aileron / flap servo covers
2 pairs
Vacuum-moulded plastic
Contents of small parts bag:
7) Servo plate
1
Poplar plywood, machined
8) V-tail joiner rods
2
Steel, pre-formed
9) V-tail support rail
1
Balsa, ready made
10) V-tail horns
2
Pre-formed rod with ball-link
11) Wing joiners
2
GRP / CFRP, 8 Ø x 140 mm
12) Wing incidence pegs
2
CFRP, 3 Ø x 20 mm
13) Wing locating peg
1
Beech dowel, 4 Ø x 38 mm
14) Wing retainer screw
1
Nylon, M5 x 20 mm
15) Motor bulkhead
1
GRP, ready made
16) Short horns (aileron)
2
Plastic, ready made
17) Long horns (flap)
3
Plastic, ready made
18) Horns, spreader plate and screws
2 sets
Plastic, ready made
19) Clevises with threaded couplers and pins
6 sets
Ready made
20) Aileron / flap pushrods
4
Steel wire with Z-bend, 75 mm
21) Fuselage formers for tail snakes
1
Wood, ready made
22) V-tail pushrods
2
Steel wire, 0.8 Ø x 800 mm
23) Wing servo mount
4 pairs
Wood, ready made
24) Captive nut
1
Ready made, M4
25) Captive nut washer
1
Wood, ready made
26) Canopy tongue
1
GRP, ready made
27) Canopy locating pin
1
1 Ø x 26 mm
28) Building instructions
1
Ready made
Essential accessories
Knife, metal file, straight edge, ruler, set of screwdrivers, 5-minute epoxy, thick and thin cyano-
acrylate, paper masking tape, soldering iron, 4 m x 0.14 sq mm twisted servo cable, 6-pin plug and
socket.
Recommended RC equipment
6 servos (each 9 - 13 mm)
Receiver (min. 5-channel)
Recommended power system
Motor:
500 Watt
Battery:
4S LiPo / LiIon
