38
Glue reinforcement R18 to the inside of the canopy opening as
shown. It will protect the front edge of the canopy opening
against wear.
Slide snake outer S2 through front wing dowel bore. Do not
glue! Place centre section of canopy R15 in fuselage (slot at
rear end resting on S2) and secure at front end with pins.
Glue side panels R16/R17 to centre section and secure with
pins. Remove canopy from fuselage and leave to dry.
R15
R18
S2
R16/R17
R16/R17
39
40
Sailplane version only:
If your LT 200 is built as a sailplane glue together parts R21
(6×) and R22 (4×) as shown, then glue to front end of
fuselage.
Electric power only:
If your LT 200 is to be equipped with electric power, glue motor
mount cover R19 to front of motor mount and secure with tape.
Make sure to match motor mounting bores in R19 with bores in
R13.
Then glue in place spacer R20 flush with R19.
R19
R20
R22
R22
R21
41
42
Bevel off front edge of elevator for suffficient control throw.
From below glue control horn R29 (1.5 mm birch) into elevator. The elevator will be attched to the
tailplane with tape at a later stage.
Thoroughly sand tailplane and elevator and round off the edges.
Secure tailpnae R23 (3 mm balsa) to building bord with
pinsand glue in place tips R24.
Glue together elevators R25/R26 and connector R27 (3×3
mm spruce) and secure with pins until dry. Glue
reinforcement R28 (1 mm birch) on top. Make sure that
slots for control horn in R25 and R28 match precisely.
R23
R29
R24
R24
R25
R26
R27
R28
R23
R30
R30
R37
R37
R31
R32
R33
43
44
Glue fin R30 to tailpane R23. Use a set square or other suitable aid to
make sure that fin is at right angles in relation to tailplane.
Glue reinforcements R37 to base of fin.
The rudder will be attched to the fin with tape at a later stage.
The vertical stabilizer consists of fin R30, rudder R31 (both 3 mm balsa) as well as
reinforcements R32 and control horn R33 (1 mm and 1.5 mm birch, respectively).
Glue reinforcements R32 to either side of rudder and secure with clamps. Make sure that slots
for control horn match precisely.
Bevel off front edge of rudder (to the right side in direction of flight) for sufficient control
throw. Then glue in place control horn R33.
Attention:
Control horns for elevator and rudder must not be located on the same side!
Carefully sand vertical stabilizer and round off the edges.
