6
IFCLITY 1006 - 5773010_00
The fan coils are shipped in stand-
ard packaging, which consists of
expanded polystyrene foam and
cardboard shells.
PACKAGING
WARNING: the fan coil is connected
to the power supply and a water
circuit. Any operation by persons
who do not possess the required
technical skills can lead to personal
injury to the operator or damage to
the unit and surrounding objects.
POWER THE FAN COIL ONLY WITH
230V, SINGLE-PHASE VOLTAGE
Any other type of power supply could
permanently damage the fan coil.
DO NOT USE THE FAN COIL
IMPROPERLY
Do not use the fan coil for animal hus-
bandry applications (e.g. incubation).
AIR THE ROOM
Periodically air the room in which
the fan coil has been installed. This
is particularly important if the room
is occupied by many people, or if
gas appliances or sources of odours
are present.
ADJUST TEMPERATURE ADEQUATELY
The room temperature should be
adjusted in order to provide maxi-
mum comfort to the people in the
room, especially if they are elderly,
children or sick people; avoid differ-
ences over 7°C between the outdoor
temperature and the temperature
inside the room in summer.
In summer, a temperature that is too
low causes higher electrical con-
sumption.
CORRECT AIR JET AIMING
ADJUSTMENT
Air coming out from the fan coil must
not reach people directly; in fact,
even if the air is warmer than the
room temperature, it could cause
a cold sensation and result in dis-
comfort.
DO NOT USE EXCESSIVELY HOT
WATER
Clean the fan coil with a soft cloth
or sponge soaked in water not over
40°C. Do not use chemical products
or solvents to clean any part of the
fan coil. Do not spray water on the
outer or inner surfaces of the fan coil
(it might cause short circuits).
CLEAN THE FILTER FREQUENTLY
Cleaning the filter frequently guaran-
tees enhanced operating efficiency.
Check whether the filter is very dirty:
in this case, clean it more often.
Clean frequently; remove the accu-
mulated dust with a vacuum cleaner.
Once the filter is clean, refit it to
the fan coil following the removal
instructions but in reverse order.
SUPPLEMENTARY CLEANING
The fact that the blades of examinable
shrouds can be removed (operation
done only by adequately skilled
technicians) ensures a thorough
cleaning of the internal components,
which is particularly important when
installing the unit in crowded areas
or venues requiring high hygiene
standards.
DURING OPERATION
Always leave the filter fitted on the
fan coil during operation (otherwise
dust in the air could soil the coil
surface area).
WHAT IS NORMAL
In cooling mode, water vapour may
be present in the air delivery of the
fan coil.
In the heating operation, a slight hiss
might be heard close to the fan coil.
Sometimes the fan coil might give
off unpleasant smells due to the
accumulation of substances present
in the air of the room (clean the filter
more often, especially if the room is
not ventilated regularly).
While the unit is functioning, there
could be noises and creaks inside
the device due to the various ther-
mal expansions of the elements
(plastic and metal), but this does
not indicate any malfunction and
does not damage the unit unless the
maximum input water temperature
is exceeded.
MALFUNCTIONS
In case of malfunction, cut off power
to the unit, then energise it again
and restart the device.
WARNING! Do not attempt to repair
the unit by yourself; this is highly
dangerous!
If the problem occurs again, call the
local After-Sales Service immediately.
This section is reserved for the After Sales
Service only. On the Inverter board there
are 2 LEDs (Alarm / Power) indicating
the operating status of the unit. The table
for decoding the messages is given in the
chapter on installation.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull, tread on
or crush the electric power cable,
or fix it with nails or drawing pins.
A damaged power cable can cause
short circuits and injure people.
DO NOT OBSTRUCT THE AIR OUTLETS
BY PLACING OBJECTS INTO THEM
Do not put anything in the air outlet
slots.
This could injure people and damage
the fan.
WARNING
Do not let children or unskilled peo-
ple use the device without supervi-
sion. Remember also that the device
must not be used by children as a
plaything.
IMPORTANT INFORMATION AND MAINTENANCE