USER MANUAL
COOLMAX SRX – Wall Mount
Australian Energy Research Labs
AER09 – Rev 1.2.3
31
st
October 2022
14
AER09 REV 1.2.3
Powering Up
The CoolMax SRX will power up when a PV Voltage above 60Vdc is applied.
Programming the Device
When the CoolMax SRX is first powered on,
the device will run a self-test and then the LED
indication strip will flash yellow to indicate
no charge profile has been configured.
The CoolMax SRX is programmed via the
USB-C
port located inside the access cover
as demonstrated in
Figure 4
to the right.
The AERL Link Software for Windows 10/11
can be downloaded at the URL/QR below.
Instructions for setting the charge profile
located on
Page 18
.
Operation
Figure 4:
USB-C Programming Port
CAUTION – Equipment Damage
Ensure that the battery is connected to the output prior to powering the device up
from the PV.
link.aerl.com.au
