RECALIBRATION OF ACCELEROMETER
If your TURBO-X begins to be unstable during flight, drifts heavily in
one direction or troubleshooting doesn’t work please do the following:
1. Turn off Drone and Controller
2. Make sure that all batteries are fully charged
3. Place Drone on flat LEVEL surface
4. Turn Drone on, Turn Controller on and pair (page 4)
5. Keep Throttle (Left Stick) at lowest point
6. Set speed level to TURBO-X (three beeps, page 7)
7. Push the Throttle (Left Stick) to Lower Left, HOLD
8. Push Control (Right Stick) to Lower Left, HOLD
9. Drone will flash for 1-2 seconds indicating success.
10. Take off and enjoy!
Calibration
POWER FAILURE FROM CRASH
If your TURBO-X crashes, becomes entangled or blades jam, it should
automatically shut itself off to prevent further damage or danger.
If battery is fully charged, you should be able to turn the power switch
off and then back on and repeat the pair cycle (page 4).
If the drone fails to turn back on, please turn it off and fully charge.
Be sure to watch the drone after a bad crash to make sure the battery
does not overheat while charging; if it does, please dispose of it.
