GUIDE#: BT-ascEnT-001
6
STEP 7
steP 8
STEP 9
remove the tower from the boat and drill the holes with your 5/8”
drill bit. after your holes have been drilled, remove the masking
tape from the rear mount location.
Then place the tower back on the location with a rubber
mounting plate between the tower mount and the deck
surface. on the underside of the deck a backing plate
will also need to be installed.
Note: In the case where the deck of your boat is less then
1/4” thick, a reinforcing kit is required to thicken and rein-
force the deck in the mounting locations.
once the mount and its pats are assembled they can
then be secured in position with a wrench.
Note: When folding the tower the mounts will rotate on the
surface of the deck. When fastening the mount to the boat
deck, ensure that the mount is securely tightened in posi-
tion but not overly tight that it will prevent the mount from
rotating.
Attach the rear bars to the front bars with the mounting fittings and
fasteners supplied.
all mounts are designed to swivel to ensure a square and even
installation.
Once all the fittings are correctly aligned they must then be firmly
secured in position with an allen wrench. We recomend using a
loctite Threadlocker during the installation of these fasteners.
MoUnT
nylon WashEr
rUBBEr
BoaT DEck
rEInforcEMEnT
BackInG plaTE
WashEr
nylon lock nUT
