24/28
TF6751_D
Aereco S.A.
Any curve between the minimum (a) and maximum (i) curves presented in the graph below can be obtained. The number of
possible adjustments between these curves is infinite. Curves (b) to (h) are given as examples, not exhaustive.
5.2.
MS mode
1) Power up the appliance, which then waits for a setpoint command from the management system.
For the rest of the starting up process, refer to the installation manual of the management modules.
Once the MS mode has been activated, the appliance should start.
The motor technology used may lead to starting errors. If this happens, the appliance fails to start and begins
vibrating slightly. Do not touch anything; the appliance will itself initiate a starting cycle, until it starts
MS mode
Driving side
