5
Fig. 1
Model
Airflow
m
3
/h max
Static pressure
Pa max
Power
W max
Sound pressure
dB(A) @3m
Quasar N
95
47
8
25
Quasar T
95
47
8
25
Quasar 2S BB
105/70
53/22
8/5
26/22
Quasar N
Equipped with high quality sleeve bearing motor.
BB version (on request): motor mounted on ball bearings that guarantee a longer product
life cycle (30,000 h) and suitable for cold climates.
Single speed operation.
Wiring diagram fig.15A.
Quasar T
Equipped with high quality sleeve bearing motor.
BB version (on request): motor mounted on ball bearings that guarantee a longer product
life cycle (30,000 h) and suitable for cold climates.
Single speed operation: the fan is provided with a timer circuit which is adjustable from
aprox. 1 minute to 25 minutes via trimmer (fig. 16B).
Operation: connected according to the diagram in fig. 15B, after the light is switched on,
the fan activates with a delay of max 1.5 seconds. After the light is switched off, the fan
continues to function for a pre-set period of time.
Quasar (fig. 1) is a mixed-flow fan designed to ensure air extraction in small/medium-sized
rooms such as bathrooms, toilets and kitchens.
Suitable for air discharge directly to the outside or in the presence of medium length duct.
Wall or ceiling installation (fig.2).
• Material: High quality, impact and UV-resistant ABS colour RAL 9010.
• Rear reinforcement ring to prevent spigot deformation during installation.
• Mixed flow impeller to optimise quietness and efficiency.
• Single phase induction motor with integral thermal protection.
• The fan is double insulated: no earth connection is required.
• Suitable for intermittent or continuous operation.
• IP45 degree of protection.
• Power supply 220V to 240V~ 50/60Hz.
• Do not obstruct the fan or exhaust grille to ensure optimum air passage.
• Ensure adequate air return into the room in compliance with existing regulations in
order to ensure proper device operation.
• If the environment in which the product is installed also houses a fuel-operating device
(water heater, methane stove etc., that is not a “sealed chamber” type), it is essential
to ensure adequate air intake, to ensure good combustion and proper equipment
operation.
• Install the product so that the impeller is not accessible from the air outlet side as
verified by contact with the Test Finger (test probe “B” of the norm EN61032) in
compliance with the current safety regulations.
INTROdUCTION
TECHNICAL SPECIFICATIONS
VERSIONS
