AER domino 3, Manual

Page: 15 / 18

7. Effect chart
number description type
01 Long warm corridor Reverb
02 Xlarge marble church Reverb
03 Xlarge wood church Reverb
04 Large soft hall Reverb
05 Large bright hall Reverb
06 Mid vocal hall Reverb
07 Small dark room Reverb
08 Small soft room Reverb
09 Ambience delay Reverb/Delay
10 Swimmingpool Reverb
11 Phasing chorus Chorus
12 Frozen chorus Chorus
13 Ambient reflections Delay
14 Long delay Delay
15 Fast delay Delay
16 Spacy delay Delay
17
Notes:
1. Input sensitivity
Input sensitivities refer to 2 x 85 watts into 4 ohms,
full gain and master settings, neutral tone control
settings, and 1 kHz sine-wave test signal.
2. Noise and dynamic range
Equivalent input noise voltage was obtained by
measuring noise voltage at speaker output and
dividing by the effective voltage gain of the amplifi-
er. Full gain and master settings, neutral tone control
settings, input shorted, measuring bandwidth
20 Hz – 20 kHz.
Dynamic range: Range between output signal at
limiter threshold and A-weighted output noise with
master volume in zero position.
3. Output levels
Output levels refer to 50 mV / 1 kHz sine-wave test
signal at channel 1 input in line mode, full gain and
master settings, and neutral tone control settings.
4. Options
he following options can be activated by jumper
settings.
9 V phantom power
can be enabled for
channels 2 and 4 if required. (Not recommended
generally, because only a common switch will be
available for channels 1/2, and channels 3/4 respec-
tively) 4 8 V phantom power can be disabled for
each of the four channels.
DI output can be changed from post-equalizer to
pre-equalizer (tone controls) for each channel, and
disconncted from aux in, internal, and external
effects.
Send level can be made dependent on eff. send
controls for each channel.
Rec out level can be made dependent on pre out
control.
0 dBV = 1 V
Specifications and appearance subject to change
without notice.