AEQ SWING, Quick User Manual, Page: 2 / 2

AEQ SWING Quick User’s Guide (EURO ISDN) - Revision 02/07
4) Choosing a Coding Mode:
•
The Swing usually comes ready to place a call in G.722 Statistical mode, but other
modes can be selected.
Press the Coding button on the keypad to access the list of
coding modes that can be selected.
•
The coding method used on the last call will appear on the LCD screen. By pressing the
(
Á À
) keys all other methods will be accessed.
Note: G.722 and G.711µ are the most commonly used, so all other modes can be found
under the ADVANCED option.
•
Press the Yes button to select the coding method desired. The coding method will be
saved even after the equipment is turned off.
5) Placing a call on ISDN:
•
Press the ISDN button on the keypad, the LCD screen will show the lines that are
available depending on the coding mode being used. Example: If MPEG128 or LD-2 is
being used, two lines will be available, but in all other modes only one line will be
available.
•
There will be a ‘ >’ over the line on which the call will be placed, the (
Á À
) keys allow
movement between the lines. Usually the > will be pointing at the line on which the call
should be placed on.
•
Once the line has been selected press the Yes button, which will allow entering the
targeted phone number. The number will be entered using the keypad, and erasing can
be accomplished by using the
Á
key.
•
Finally, when the targeted phone number is in correctly press the Yes button and the call
will be placed.
Note: both the codec that is placing the call and the one that is receiving have to be in
the same coding mode.
•
In 128 modes, the call should be placed on L1 first, then after L1 connects and
synchronizes, the call on L2 can be placed.
•
Press the No button to end the call.
6) Using the Analog Line:
•
The swing allows an ISDN communication and an analog communication to be
established simultaneously, or individually if desired.
Connect the RJ-11 cable in the
Analog Tel. Line connector (9) on the back of the equipment.
•
Press the
℡
button on the keypad: this will connect the phone line and the dial tone
should appear on headphones.
•
Press the Dial Pad button to activate the keypad, this will allow the target phone number
to be entered.
•
Press the
℡
button again to end the call.
•
For other analog line options please refer to the User’s Manual.