Intin Manual
ENG
3.
Press the Include button on your Minimote.
4.
If Siren has been successfully linked to your Z-Wave network, its Network LED will no
longer blink when you short press and quickly release the Action Button on Siren. If
the linking was unsuccessful and the Network LED continues to blink when you short
press and quickly release the Action Button repeat the above steps.
5.
Press any button on your Minimote to take it out of installation mode.
With your Sir
en now working as a part of your smart home, you’ll be
able to configure it from
your home control software. Please refer to
your software’s user guide for precise instructions
on configuring Siren to your needs.
You’re able to test your Siren’s speaker sy
stem manually.
Please note that the speaker system is 105 dB and very loud
–
we recommend only testing
your Siren while wearing the necessary ear
protection given you’ll need to be next to your
Siren while manually testing it. To manually test Siren, press and hold the Action Button for 5
seconds.
Associating different tones with different events.
Your Siren contains 5 different alert tones, and each can be set to be used for a different type
of emergency. One tone is more relevant to intruder alerts, while others are more relevant to
the likes of water leaks, medical emergencies and door chimes. This functionality can be
setup and configured via supporting Z-Wave gateways. Please refer to your gateway's user
manual for further information.
Removing your Siren Gen5 from a Z-Wave Network
Your Siren can be removed from your Z-Wave network at any time.
You’ll need to use your Z
-
W
ave network’s main controller to do this
and the following instructions tell you how to do
this using Aeotec by
Aeon Labs’ Z
-Stick and Minimote controllers. If you are using other
products as your main Z-Wave controller, please refer to the part of their respective manuals
that tells you how remove devices from your network.
