6
For technical inquiries
e-mail us at
or
call us at
800.992.3000
4. Reassemble Vehicle
a. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact
any part of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.
b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are
properly tightened.
d. Reconnect negative battery terminals and start engine. Let the vehicle idle for 3 minutes. Perform a final
inspection before driving the vehicle.
5. CARB Sticker Placement
a. The C.A.R.B. exemption sticker, (attached), must be visible under the hood so that an emissions inspector
can see it when the vehicle is required to be tested for emissions. California requires testing every two years,
other states may vary.
6. Service and Maintenance
a. It is recommended that you service your AEM
®
Dryflow™ filter every 20,000 miles for optimum performance.
Use AEM Dryflow cleaning kit part # 21-110.
b. Use aluminum polish to clean your polished AEM
®
intake tube.
c. Use window cleaner to clean your powder coated AEM
®
intake tube.
(NOTE: DO NOT USE aluminum
polish on powder coated AEM intake tubes).
AEM Air Intake System Warranty Policy
AEM
®
warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty due to
mechanical damage (i.e. improper installation or fitment), damage from misuse, accidents or flying debris. AEM will
not warrant its powder coating if the finish has been cleaned with a hydrocarbon-based solvent. The powder
coating should only be cleaned with a mild soap and water solution. Proof of purchase of both the vehicle and AEM
intake system is required for redemption of a warranty claim.
This warranty is limited to the repair or replacement of the AEM part. In no event shall this warranty exceed the
original purchase price of the AEM part nor shall AEM be responsible for special, incidental or consequential
damages or cost incurred due to the failure of this product. Warranty claims to AEM must be transportation prepaid
and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of product and
is nontransferable. Improper use or installation, use for racing, accident, abuse, unauthorized repairs or alterations
voids this warranty. AEM disclaims any liability for consequential damages due to breach of any written or implied
warranty on all products manufactured by AEM. Warranty returns will only be accepted by AEM when accompanied
by a valid Return Merchandise Authorization (RMA) number. Credit for defective products will be issued pending
inspection. Product must be received by AEM within 30 days of the date RMA is issued.
If you have a warranty issue, please call (800) 992-3000 and our customer service department will assist you. A
proof of purchase is required for all AEM warranty claims.
10-380A
08/16/10
