10
z. Mount the heat shield lid assembly onto the air
box using 4 M6 buttonhead bolts (1-112) and 4
plastic washers (1-3001); tighten using a 4mm
Allen wrench. Start all 4 bolts before fully tighting.
aa. Loosely install the turbo elbow coupler (5-1061)
onto the turbocharger inlet using the provided #28
hose clamp. Fully seat the turbo bypass connec-
tor into the bypass port of the coupler. Use glass
cleaner to ease installation of the interference-fit
connector into the bypass port if necessary.
x. Remove the waxed paper backing from the sili-
cone foam window gasket (5-1060-1) by pinching
the gasket on its sides, then pealing up the edge of
exposed paper. DO NOT USE A KNIFE TO
REMOVE THE PAPER BACKING.
y. Place the powder coated air box heat shield lid
(20-8517) on a table with the part number stamp
facing DOWNWARD. Apply the adhesive side of
the silicone gasket (5-1060-1) on top of the heat
shield, aligning it with the window cutout as shown.
Press down on the foam gasket to ensure adhe-
sion to the heat shield lid.
NOTE: The adhesive must set for a full 24
hours before use for best results.
