Read and understand these instructions BEFORE attempting to install this product. Failure to
follow installation instructions and not using the provided hardware may damage the intake
tube, throttle body and engine.
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect both battery terminals.
e.
Raise the front of the vehicle with a jack. Refer to your owner’s manual for proper jack and jack stand placement to
properly support vehicle. Support your vehicle using properly rated jack stands before wheel removal or while
working under the vehicle.
NEVER WORK UNDER A VEHICLE WITHOUT USING JACK STANDS.
f. Remove the driver side wheel.
g.
Remove the driver’s side fender liner.
h. Do not discard stock components after removal of the factory system.
2. Removal of stock system
Breather hose
Upper clamp
a. Stock air box system installed.
b. Pull breather hose off of valve cover. Loosen the
upper and lower hose clamps on the stock inlet tube.