American Electric Lighting a division of Acuity Lighting Group, Inc. Conyers, GA
DRAWING NO. B60974 REV E
(BACK)
©2003 ACUITY LIGHTING GROUP, INC.
PART NUMBER 057-70-60974
ALTERNATE
SOCKET
BRACKET
LOCATION
CLOSURE
SCREW
REFLECTOR
SCREWS (2)
SOCKET
BRACKET
HORIZONTAL REFLECTOR
VERTICAL REFLECTOR
THE SOCKET BRACKET HAS THREE SETS OF SOCKET MOUNTING
HOLES (BACK, CENTER, & FRONT) CONSULT CHART FOR DESIRED
BEAM PATTERN. IF BEAM PATTERN DESIRED IS POSSIBLE WITH
REFLECTOR SUPPLIED REMOVE SOCKET SCREWS AND MOVE SOCKET
TO POSITION INDICATED IN CHART.
IT IS ALSO POSSIBLE TO ROTATE THE REFLECTOR 90
í
IN HOUSING.
TO DO SO FIRST REMOVE THE TWO SCREWS HOLDING THE REFLECTOR
IN PLACE AND REMOVE REFLECTOR. NEXT REMOVE THE (ONE) SCREW
HOLDING THE SOCKET BRACKET DOWN AND LIFT SOCKET BRACKET OFF
OF LOCATING BOSS. PLACE SOCKET BRACKET ON THE OTHER SOCKET
BRACKET BOSS AND REPLACE SCREW. ROUTE SOCKET WIRES SO WHEN
REFLECTOR IS REPLACED THEY ARE NOT BETWEEN REFLECTOR AND
HOUSING. REMOVE FIBER SHIELD FROM REFLECTOR AND REMOUNT ON
OTHER SET OF HOLES. REPLACE REFLECTOR.
B E A M P A T T E R N C H A R T
REFLT FINISH
DIFFUSED
REPORT NO.
AE4703I.PHT
AE4706I.PHT
AE4713I.PHT
BEAM SPREAD
6H X 6V
7H X 6V
5H X 3V*
SCKT POSITION
CENTER (B)
HPS
MH
OPEN BEZEL BY LOOSENING THE 1/4"
CLOSURE SCREW LOCATED AT TOP OF
FLOOD. LOOSEN THE 8 LENS CLIP
SCREWS AND ROTATE CLIPS.
REMOVE OLD LENS PARTS AND INSTALL
NEW LENS. ROTATE LENS CLIPS
AND TIGHTEN LENS CLIP SCREWS.
LENS REPLACEMENT
CENTER (B)
7H X 6V
AE4694I.PHT
SEMI SPECULAR
VERTICAL
MH
CENTER (B)
SEMI SPECULAR
SEMI SPECULAR
---
BACK (A)
HORIZONTAL
---
---
---
HPS
SEMI SPECULAR
AE4715I.PHT
AE4721I.PHT
AE4724I.PHT
5H X 4V*
5H X 3V*
5H X 5V*
CENTER (B)
---
---
FRONT (C)
5H X 2V*
AE4711I.PHT
SEMI SPECULAR
---
CENTER (B)
DIFFUSED
DIFFUSED
---
CENTER (B)
HPS
HPS
MH
MH
MH
---
BACK (A)
5H X 4V*
AE4722I.PHT
SEMI SPECULAR
* BEAM SPREAD BASED ON 20% OF MAX. CANDLEPOWER
REFLECTOR AND SOCKET ADJUSTMENT
