15
Using the Optional Battery Assembly and Mobile
Power Adapter
Note:
If a power receptacle for the mobile power adapter is
available, use it. This will charge the battery assembly
and allow maximum use while traveling.
Note:
To charge the battery assembly without the CPAP
device attached, use the steps below.
Complete the steps in the section above,
Using the Optional Mobile
Power Adapter.
1.
Hold the square connector of the
mobile power adapter so the arrow
symbol appears on the bottom.
2.
Insert the square connector into the
receptacle on the back of the battery
assembly.
3.
Insert the 12V connector into the 12V mobile power
receptacle (e.g. cigarette lighter).
16
Using the Everest® 3 CPAP with a Power Source
Connected
When a power source is connected to the Everest 3 CPAP
device, the CPAP displays the total number of therapy hours
♠
and a flashing hourglass symbol for 3 seconds.
Following the initial display of the therapy hours, the CPAP
device is in Standby mode—the CPAP is ready, the blower is
off, and the display shows the following:
Note:
If the CPAP loses power while delivering therapy, it will
immediately resume delivering therapy as soon as power
is restored (the CPAP will skip the initial therapy hours
and Standby screens)
♠
Therapy hours = operating time at therapy pressure, as monitored by the device.
Ramp time and Interface Interrupt time are not included in therapy time.
