PROCEDURES OF PROGRAMMING
(1)
Entry into programming
PRESS KEY
＊
→
Enter the programming code (4-8 digits, default code is 1234)
→
# (The amber LED and green LED lighted,
signifying entry into the programming mode)
(2)
Recording the new programming code (This procedure must be done)
Warning: For security purpose, the owner should change the default programming code (1234) to
owner’s private programming code (Master Code) before use of the new access control
keypad.
PRESS KEY 0
→
Enter the new programming code (4-8 digits)
→
#
→
Repeat the new programming code
→
#
(3)
Programming the Open–door mode
PRESS KEY 3
→
01
→
# (Open door by User Code)
(4)
Programming the door–open time
PRESS KEY 4
→
(01-99 seconds)
→
# (Setting door-opening time 1- 99 seconds)
NOTE : Factory setting “door-opening time is 3 seconds”
(5)
Recording the User Code (Use either A or B)
A. Single User Code (Common User Code)
PRESS KEY
5
→
00
→
Enter the User Code (4-8 digits)
→
#
＊
＊
＊
＊
Deleting the common User Code
When enter new common User Code the old one will be deleted automatically
B. Multi-User Codes
(Assign a number of any 3 digits as the User ID Number for each User Code, the User ID Number is not allowed to repeat use in
the programming, keep the User ID Number as a record of an user)
PRESS KEY
5
→
01
→
Enter the User ID Number (3 digits)
→
Enter the User Code (4-8 digits)
→
# (Confirming the code
length) (Green LED flash)
→
# (Green LED stop flash) (confirmed entering is completed)
NOTE : If continue to record more User Codes, at the end of each recording, it is no necessary to press the key # per each time, to
repeat the above steps until all User Code recordings are finished. Finally to press the key # to confirm all recordings are
completed.
＊
＊
＊
＊
Deleting the User Code recorded (Multi-User Codes)
PRESS KEY
5
→
02
→
0000
→
# (Deleted all the User Codes)
PRESS KEY
5
→
02
→
Enter the User Code to be deleted
→
# (Deleted the User Code)
PRESS KEY
5
→
02
→
Enter the User ID Number of the User Code
→
# (Deleted the User Code of the User ID Number)
(6)
Programming User Code entry mode
MANUAL code entry checking mode
PRESS KEY 70
→
0
→
# (Manual entry mode, have to press the key # follow the User Code entered to confirm the code length
of the User Code entered. The User Code can be 4-8 digits)
AUTO code entry checking mode
PRESS KEY 70
→
1
→
# (Auto entry mode, the User Code must be set in the same code length as the program code. No need to
PRESS KEY # to confirm the code length of the User Code entered. The User Code can be 4-8 digits)
Note : Factory setting
“
Manual code entry checking mode
”
(7)
End of programming
Exit programming mode in 60 seconds
PRESS KEY
＊
＊
＊
＊
to exit programming mode and return to normal operation status (Standby mode)
2
