Page 6
STEP 3
Setting the Zone Codes
What is a Zone Code?
The Zone code sets the
desired behavior of a
sensor. Every PIR and
magnetic door contact has
a zone setting.
How do I set the Zone
Code?
The code is set by
modifying switches 10,11
and 12. Please refer to the
table opposite when
setting the zone setting.
ZONE
10
11
12
Usage
Zone 1
ON
OFF
OFF
Entry/Exit
A sensor set to Zone 1 will give you a 20
Second entry/exit delay in this area.
Normally
used for magnetic door contacts)
Zone 2
OFF
ON
OFF
Instant Walk through
A sensor set to Zone 2 will give you a 20
second entry/exit delay ONLY if a zone 1
sensor has been triggered first. If not, the
sensor will trigger the alarm immediately if
set.
Normally used for a PIR in your entrance
hallway.
Zone 3
OFF
OFF
ON
Instant
A sensor on Zone 3 will trigger the alarm
immediately if set.
Zone 4
ON
ON
OFF
24 Hour Protection
A sensor on Zone 4 will trigger the alarm
immediately wether it is set or not.
Normally
used for wireless smoke detectors.
NOTICE:
You can skip this
step if you do not
wish to change the
default settings of
your sensors.
i.e. PIR on Instant/
Walk through and
both door contacts
set to Entry/Exit
mode.
Page 11
STEP 8
Installing the door contacts
Do I have to use these on doors?
No, your magnetic contacts can also be used
to detect the opening of windows and
cabinets.
Must the magnet and transmitter be
lined up as below?
Yes.
STEP 1
Remove the
magnet cover.
STEP 2
Fix the magnet to
the door frame
using the
supplied screws
(wooden door
only)
STEP 3
Set your
SolarGuard to
BATTERY TEST
MODE. Open the
sliding cover on
the transmitter.
STEP 4
Install the A23
battery, ensuring
it is in the correct
alignment.
STEP 5
Mount the
transmitter
section to the
door using the 2
supplied screws.
Replace the
cover.
SOME UPVC DOORS CAN
INTERFERE WITH THE OPERATION
OF THIS UNIT.
NEVER USE SCREWS TO ATTACH
THIS DEVICE TO A UPVC DOOR.
10mm
Max.
