- 3 -
TSE-N 05.00 A. B.
599 50 77 62
EN
Disassembly and Assembly of Separate Components
Lid
16
Guided on both sides with hinge and lid necks. When removing,
raise the lid and press the flaps with the lid necks outward.
When closing the lid, the paper filter must be put in, raise the lid in
upright position and insert the hinge and lid necks in both sides.
Lock Key
13
Press key to the front using a screwdriver between lid 16 and key.
Locking Piece
15
Take out the spring wire, press the 2 clips of the lid 16 upward one
after the other using a small screwdriver while moving that piece
forward.
Accessory Tray
17
Guided with 2 necks (axes) on both sides.
Accessory Lid
1
Press the lid in the middle of its front side down with your fingers,
the lid leaps up, press the 2 guiding necks inward and pull the lid
up.
During assembly first put the spring onto the axis, then put the lid
in open position to the necks, press downward and let it lock in; if
necessary, place the spring into the guide groove.
Accessory Lid Lock
14
Put a small screwdriver into the support, unlock it and press it
down.
During assembly put the guide bolt into the support and press it
from below to top into the device.
Paper Filter Safety
Device
22
Apply the screwdriver inside and press outward.
Switch Key,
Stop Key
18
The keys are snapped twice each.
It is better to raise and/or remove the lid completely when
performing these activities.
During disassembly press the key and put the screwdriver between
the key and potentiometer panel, slider panel respectively control
panel or key 4 (250 W, 110 W), apply to the snap-in catches and
press outward (possibly by turning), put the screwdriver between
the key and printed panel 2 (inclined ribs and press outward
(possibly by turning).
During assembly unlock the printed panel 2 respectively remove it
completely. Guide both outside snap-in catches of the key into the
pockets inside the rim of the support part 8 and press the key at
the inside down (possibly with a slight beat of your ball of the
thumb), so that the snap-in catch will be locked inside the
potentiometer panel 3, slider panel 20 respectively control panel or
key 4. Locking in respectively putting on the printed panel 2 leads
to the second lock of the key.
Printed Panel
2
Unlock the snap-in catches, which are each snapped in twice on
the left and right side, one after the other, using a screwdriver.
Potentiometer Panel,
Slider Panel and Blind
Panel
3
20
Only mounted on, can be taken off.
3 – Keys
4
Can be taken off and mounted on again; by mounting on the
printed panel 2 the keys are locked
