7. One-touch memory
a. Storing a number in the memory
b. Dialling a number from the one-touch memory
8. Pause Function
9. FLASH button
You can store 3 telephone numbers in the one-touch memory.
In on-hook state:
1. Press
or
button to select the incoming number or
button
repeatedly to select the outgoing number you desire or input the
telephone number manually.
2. Press the
button and the LCD shows
.
3. Press the desired location button (
~
) to store the number.
: To update the number stored in the one-touch memory, just
repeat above steps to store a new number to replace the old one.
Either in on-hook or off-hook state, you can press one of the memory
button (
~
) to dial out the matching number.
This feature allows you to insert a temporary pause during dialling
sequence. For example, dialling an international number (e.g.: 011-
886-22-795-1234), some telephone company systems will not register
the entire number entry without a pause between the prefix numbers.
You may have to dial 011-
, dial 886 -
. This allows adequate
time for the phone number to register with the telephone company's
system and complete the call.
Press
button to terminate a call and institute a dialling tone for
another call or to get another call from "Call Waiting" (a special
telephone service).
If you do not have any special telephone service, such as Call
Waiting, pressing
button during a call may disconnect your
current conversation.
s t
OUT
SET
M1 M3
NOTE
M1 M3
PAUSE
PAUSE
FLASH
NOTE:
FLASH
STORE IN
7
6
1. Ringer volume selection
2. Preparation dialing function
3. Speaker Function
4. Redial Function
5. SET Button
6. DEL Button
HI LO OFF
HI
LO
OFF
DEL
REDIAL
REDIAL
SET
DEL
Set the ringer volume switch to the desired position (
/
/
). To
have the maximum ringer volume, move the ringer volume switch to
the
position. To have a low ringer volume, move the ringer volume
switch to the
position. If you would prefer the ringer not to disturb
you, move the ringer volume switch to the
position.
In the standby mode, pre-dial the telephone number you want to call
(you can check the number before dialing and use
button to
delete the incorrect digit), then press
button to dial it out.
To switch your call to speakerphone, press the
button and replace
the handset in the cradle. To switch back, just pick up the handset. In
speaker state, you can make or answer calls.
Lift the handset or press the
button, then press the
button
to redial the last dialled number.
In the standby mode, press the
button to enter the menu.
In the on-hook state, press the
button to delete the incorrect digit
when you set the code. In menu mode, use the button to exit from the
menu. When the LCD shows the CID number, press the button to
delete the record. If you hold the button for more than 3 seconds, all
the CID numbers will be deleted.
FUNCTION BUTTONS