AEG SCS61826TS, User Manual

Page: 12 / 68

Problem Possible cause Solution
The compressor operates
continually. Temperature is set incor-
rectly. Refer to "Operation".
Many food products were
put in at the same time. Wait few hours and then check
the temperature again.
The room temperature is
too high. Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly. Refer to "Closing the door".
The "Frostmatic function"
is switched on. Refer to "Frostmatic function".
The compressor does not
start immediately after
pressing the "Frostmatic",
or after changing the tem-
perature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows inside the refrig-
erator. Food products prevent the
water to flow into the wa-
ter collector. Make sure that food products
do not touch the rear plate.
The water outlet is clog-
ged. Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The "Frostmatic function"
is switched on. Switch off "Frostmatic func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "Frostmatic function".
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tem-
perature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
www.aeg.com 12